Ford Falcon XW XY 6 Cyl 221 250 Aeroflow Black Alternator 100 Amp Internal Reg
Aeroflow Stealth Black 100 Amp Alternator with Internal Regulator Suitable for Ford 6 Cylinder 200, 221, 250 Engines as fitted to. XR XT XW XY Falcon. Aeroflow has become synonymous with premium quality performance products. Aeroflow's objective has been to incorporate state-of-the-art manufacturing, aerospace quality materials and rigid quality controls to produce quality performance products at extraordinary value, and they've done it again with their range of high performance intercoolers. Aeroflow alternators are manufactured with 100% New components, with completely sealed bearings for reliable operation. Aeroflow alternators have a high Amperage output during idle operation and feature heavy duty internals and regulators for a stable output, and can be wired for either 1-wire or 3-wire installation Assembled with top quality components and factory load tested to meet or exceed OEM specifications and ensure the highest output possible at low RPM. Supplied in a one-wire hookup configuration enabling you to run a single wire from the alternator to the battery (positive). Electroplated Black for a functional and durable finish. Electroplated black for a functional and durable finish. Can be used in either 1 wire or 3 wire hookup configuration.
Factory load tested and certified before being packed. Supplied and fitted complete with matching black alternator pulley. Suitable to replace existing 1 wire, V-Belt type, internal regulator Ford style alternator.
Mounts measure approximately 21mm outside depth on the short side, 76mm outside depth on the long side. The measurement between the mounts from the inside edge, to inside edge is 166mm. The measurement between the mounts from the bolt centres is 6.60. Utilizes the the standard GM 10SI style case with 6.600 bolt centres.
Total length from the front of the rotor shaft to the deepest point at the rear of the case is approximately 165mm. The measurement from the front face of the alternator body, to the front face of the alternator pulley is 36mm.
Please use this measurement to check that this alternator will match your belt line. Please use the above measurements and information to compare to your original alternator, to ensure correct fitment for your vehicle.